Zig-Zags

In past posts I’ve used the term zig-zag to describe certain track patterns. In this article I’d like to delve more deeply into how zig-zags arise and what they can tell us about the animals that make them. When we humans walk in a relaxed, natural manner we place our feet in a zig-zag pattern because each foot falls to its own side of the line made by our moving center of gravity, the center line of the trail. It’s easy to verify this: Just walk naturally in snow or mud or on a dry surface with wet feet and then look at your tracks. The same logic applies to birds, so we often see patterns like the one in the next photo, made by a turkey walking from left to right. Each print angles inward, which helps to distinguish right from left. The sequence, starting at the left, is right, left, right, left, right.

Two legged zig-zags are pretty straightforward, but four-footed animals also create zig-zags, and it’s not as easy to understand how a four-footed animal can do that. Watching animals helps, but it’s hard to follow foot placement when animals are moving in real time. Fortunately for us twenty-first century trackers, there’s a tool that can bridge the gap–the internet. So let’s take a look at a video of a horse. If you click on this link: Bing Videos, then click on horses walking youtube and start the video, you’ll see a horse walking in slow motion. Notice that as each front foot leaves the ground the rear foot on the same side comes down in the spot just vacated by the front foot. The video doesn’t show the pattern on the ground, but it’s easy to see how the horse leaves a series of double impressions, each one a front track overlaid by a rear track. And since the feet on each side fall to their own side of the center line, the overall pattern is a zig-zag. The trail in the next photo, made by a deer walking from bottom to top, is a good example of a zig-zag made by a four-footed animal.

But all zig-zags aren’t the same. The physical characteristics of animals vary, and this affects the kinds of patterns they leave when they walk. There are also different types of walks, with differing relative placement of the front and rear tracks. In the photo above the walk is an almost perfect direct register gait, meaning that the rear feet fell almost exactly on top of the corresponding front tracks. The next photo shows tracks made by a woodchuck walking from lower left to upper right (and just below the second impression, tracks of a squirrel bounding toward the bottom). The trail is more variable but the tracks are mostly in indirect register, meaning that the rear tracks fell partly but not completely on top of the corresponding front tracks. Starting at the lower left the track sequence for the woodchuck is: right rear on right front, left rear on left front, right rear, right front, left rear on left front. Even in this more irregular trail the zig-zag is apparent.

The width of the zig-zag, known among trackers as trail width, varies from one species of animal to another. To measure trail width, find a relatively straight part of the trail and imagine or draw out two parallel straight lines that just touch the outsides of the alternate sets of tracks. Then measure the perpendicular distance between the lines. This is diagrammed in the next photo of the indirect register track pattern made by a walking opossum heading toward the upper right.

In the next photo you see a trail made by a gray fox walking from right to left. The trail has a different look from the opossum and woodchuck trails, both because of its narrower width and also because the fox’s step lengths are longer. But the zig-zag is still apparent. Trail widths, combined with step length, can be helpful in identification, since chunky animals like woodchucks and possums make wider trails and take shorter steps than slimmer, longer-legged animals do. And trail widths are especially important when you’re considering animals with similar step lengths. For example, trail widths for a walking coyote are generally between 4 and 5 inches while trail widths for deer moving at a walk range from 5 to 10 inches. Even when the tracks are degraded or obscured by collapsing snow it’s usually possible to differentiate between a coyote trail and a deer trail.

Animals find it harder to move in deep snow, but when they’re walking their trails still show the zig-zag pattern. In the photo below a red fox walked from bottom to top leaving a zig-zag arrangement of deep holes in the snow.

All of the gaits discussed above (and the one the horse was doing in the video) fit into what I call the regular walk–also called the diagonal walk in the tracking literature. But that’s not the only kind of walk animals can do. A common variant is the overstep walk. To see a dog doing the overstep walk click on this link: Bing Videos and then click on dog gaits youtube and start the video. The recording shows a dog walking at actual speed followed by the same sequence in slow motion. If you keep your eye on the spot just vacated by a front foot you’ll see the corresponding rear foot come down a little past it. (This video also does a nice job with the amble, equivalent to the pace-walk of the raccoon, and the trot.)

The interesting thing about the overstep walk is that the pattern of tracks on the ground also makes a zig-zag, but the points of the zig-zag consist of sets of two prints, front and rear from the same side, rather than the impressions of two superimposed tracks. In the next photo you see an overstep pattern made by a house cat moving from lower right to upper left. Because a cat’s front tracks are wider and shorter than the rear ones we can see that in each set the front track is behind the rear. The sequence, starting at the lower right, is: right front, right rear, left front, left rear, right front, right rear. Among animals that are habitual walkers, overstep walks are common.

Another variation you’ll come across is the understep walk. The next photo shows the trail of an opossum doing an understep walk, heading from the lower left to the upper right. Again, the prints are arranged in sets of two, each set the front and rear from the same side. In each pair the hand-like hind track, with its thumb pointing inward, lies behind the front track with its more evenly spread toes.

We sometimes find zig-zag walking patterns in the trails of animals that aren’t habitual walkers. Fishers move mostly in bounds or lopes, but they walk when extra caution is needed or when the footing isn’t secure. The trail in the photo below was made by a fisher walking, mostly in direct register, from lower right to upper left.

Walking trails are less common for minks than for fishers, and for minks it seems to be mostly about the animal’s dislike of unstable surfaces. In the next photo a mink walked from right to left through mud (looking pretty dry in the photo but probably much wetter and slipperier when the tracks were made), leaving sets of paired tracks. But which walk is this, overstep or understep? We can tell because the middle toe in the mink’s hind print usually angles a little to the outside. So the sequence, starting at the right, is: left rear, left front, right rear, right front, left rear, left front, right rear, right front, and this is an understep walk.

White-footed mice are even less likely to walk than minks, but the next image attests to the fact that they do it on rare occasions. A white-footed mouse walked from bottom to top, leaving sets of paired tracks. The four-toed front prints lie behind the five-toed rear prints in each set, so the mouse was doing an overstep walk. The trail both before and after the walking part was on drier footing with normal mouse bounding patterns, so it was the wet mud that made the mouse shift to a walk.

Many animals get around mostly at a walk, and zig-zags abound in the tracking world. The details of the patterns can tell us a lot about the nature of the track maker. But the sight of a zig-zag for an animal whose default gait is not the walk is an even more compelling call to investigate. In addition to their help in species identification, zig-zags can tell us how animals interact with each other and with their surroundings. In this post we’ve only made a start. There are other kinds of zig-zags, and even patterns that look like zig-zags but aren’t. I’ll keep these topics for a future article. In the meantime, follow the zig-zags wherever they lead.

Turtles on the Move

One spring a few years ago, as I wandered along the banks of my local stream, I came upon a wood turtle engaged in digging a hole in a gravel bar. She was preparing to lay eggs, and she seemed to be laboring mightily. The spot was very rocky and she wasn’t making much progress.

Finding a turtle in the process of egg laying isn’t that common, and wood turtles themselves are scarce, so this was a very exciting find. But not wanting to create any more difficulty for her, I took a few photos and left. I don’t know whether she succeeded or whether she gave up and looked for an easier location.

Turtles usually find places that are more favorable for digging, like the sandy spot in the photo below. But the eggs in that nest didn’t mature. When young turtles hatch successfully they break out of their shells underground and make their way to the surface without creating much disturbance. The presence of signs of digging and shell fragments on the surface means that the nest was raided and the eggs were eaten, perhaps by a raccoon or a fox.

Although late spring and early summer are the peak times for reproduction, turtles may continue to mate through the summer and even into the fall. Pairing up and egg laying generally involve a lot of travelling, and these wide-bodied and low slung animals leave distinctive trails. The trail below was made by a diamond-back terrapin moving from bottom to top. Each line of impressions was made by the front and hind feet on one side, and the small front tracks alternate with the larger rear tracks. Between the two strings of prints you can see disturbances made by the dragging plastron, and at the very bottom of the frame there’s a small tail mark.

This turtle was walking, but the pattern looks very different from the patterns we see in walking mammals. That’s because the terrapin’s wide body and short legs prevent it from walking the way most mammals do. The turtle was doing an understep walk, the rear foot consistently coming down behind the spot where the front that moved forward just ahead of it was placed. The rear feet touched down about midway between the last front track and the one before that, so the spacing between prints is roughly even.

Here’s another turtle trail, this one made by a painted turtle moving from top to bottom on hard sand. The tracks consist mainly of claw marks, and they lie in sets of two, each set made up of a front followed by a rear. Both front and rear feet have five claws, but the front prints turn inward while rear prints point straight ahead. The gait in this photo is also an understep walk, but the hind tracks are closer to the front tracks than in the preceding example. Although the relative positions of front and rear prints can vary, turtle trails are always variations on the understep walk.

The trail in the photo below was made in dry sand, and the dragging plastron made a wide, smooth mark between the two track lines. Clear prints are not present, and it’s not obvious which way the turtle was going. Two kinds of evidence suggest that the direction of travel was right to left. First, the plastron drags seem to have smooth slopes on their right sides and steep edges on their left sides. And second, the deep holes made by the feet have drag marks pointing to the left.

Turtles are on the move, and their journeys can take them through a variety of habitats. Any area of sand, silt, or mud might show their unique parallel strings of prints and, sometimes, whimsical designs. So when you get a chance, take a detour and check out that patch of sand or muddy shoreline.